The Massey Ferguson 2745 is a 2WD row-crop tractor from the 2000 series. This tractor was manufactured by Massey Ferguson from 1978 to 1983. The Massey Ferguson 2745 is equipped with a 8.8 L (539.0 cu·in) eight-cylinder diesel engine and one of two transmissions: a 3-speed power shift transmission with 24 forward and 6 reverse gears or a mechanical shuttle transmission with 8 forward and 6 reverse gears.
The Massey Ferguson 2745 row-crop tractor used the Perkins 8.540 engine. It is a 8.8 L, 8,833 cm2, (539.0 cu·in) eight-cylinder natural aspirated diesel engine with 108.0 mm (4.25 in) of the cylinder bore and 121.0 mm (4.76 in) of the piston stroke. The compression ratio rating is 18.4:1. This engine produced 142 PS (104.4 kW; 140.0 HP) at 2,600 rpm of PTO output power.
The MF 2745 is equipped with hydrostatic power steering, hydraulic wet disc brakes, cab standard with air-conditioning, or platform configuration with four-post ROPS and 329.3 liters (87 US gal.; 72.4 Imp. gal) fuel tank.
Massey Ferguson 2745 Specifications
| General Specifications | |
| Model | Massey Ferguson 2745 |
| Length | 4,610 mm (181.5 in) |
| Width | Standard a: 2,320 mm (91.3 in) Long axle: 3,190 mm (125.6 in) |
| Height (cab) | 2,840 mm (111.8 in) |
| Wheel base | 2,790 mm (109.8 in) |
| Ground clearance | Front axle: 600 mm (23.6 in) Drawbar: 390 mm (15.4 in) |
| Weight (operating) | 6,890 kg (15,190 lbs) |
| Fuel tank capacity | 329.3 liters (87 US gal.; 72.4 Imp. gal) |
| Battery | Two 12V |
| Cabin type | Cab standard with air-conditioning or platform configuration with four-post ROPS |
| Engine | |
| Engine model | Perkins 8.540 |
| Engine type | Four-stroke, liquid-cooled, inline |
| Cylinders | 8 |
| Fuel type | Diesel |
| Displacement | 8.8 L, 8,833 cm2, (539.0 cu·in) |
| Bore and stroke | 108.0 mm X 121.0 mm (4.25 in X 4.76 in) |
| Compression ratio | 18.4:1 |
| Horsepower | 142 PS (104.4 kW; 140.0 HP) at 2,600 rpm |
| Starter | Electric |
| Oil capacity: | 18.9 L (20 US. qt, 16.6 Imp. qt.) |
| Coolant capacity: | 47.3 L (50 US. qt, 41.6 Imp. qt.) |
| Transmission and chassis | |
| Chassis | 4×2 2WD |
| Steering type | Hydrostatic power |
| Brakes | Hydraulic wet disc |
| Final drive | Planetary |
| Transmission model | Multi-Power |
| Transmission type | 3-speed power shift with dual cerametallic dry disc clutch |
| Gears | 24 forward and 6 reverse |
| Speed | Forward: 34.3 kmh (21.3 mph) Reverse: 16.4 kmh (10.2 mph) |
| Transmission oil capacity | 113.6 L (30 US. gal, 25 Imp. gal.) |
| Transmission model | – |
| Transmission type | Mechanical shuttle with dual cerametallic dry disc clutch |
| Gears | 8 forward and 6 reverse |
| Speed | Forward: 26.5 kmh (16.5 mph) Reverse: 15.0 kmh (9.3 mph) |
| Tires | |
| Front tires | Ag: 11.00-16 |
| Rear tires | Ag: 20.8-38 |
| Three-Point Hitch | |
| Category | II |
| Control type | Position control and lower-link draft sensing |
| Lift capacity (at ends) | – |
| PTO (Power take-off shaft) | |
| Rear PTO type | Independent with hydraulic clutch |
| Rear PTO speed | 540/1000 rpm |
| Hydraulic system | |
| Hydraulic type | Open center |
| Valves | 2 or 3 |
| Pump flow | High-pressure: 17.1 gpm (64.7 lpm) Low-pressure: 6.6 gpm (25 lpm) Aux. high-pressure: 17.1 gpm (64.7 lpm) |
| Steering flow | 5.7 gpm (21.6 lpm) |
Hola agradecido por su aporte, quisiera saber que bomba de inyección usa el motor 8.540 perkins que usa el MF 2745? Estaré muy agradecido si poseen dicha información, un gran saludo desde chile